توسعه های نوظهور در صنعت برق و انرژی: مجموعه مقالات یازدهمین کنفرانس مهندسی برق و انرژی آسیا-اقیانوسیه (APPEEC ۲۰۱۹)، ۱۹-۲۱ آوریل ۲۰۱۹، شیامن، چین ۲۰۱۹
Emerging Developments in the Power and Energy Industry: Proceedings of the 11th Asia-Pacific Power and Energy Engineering Conference (APPEEC 2019), April 19-21, 2019, Xiamen, China 2019

1. Cover

2. Half Title

3. Title Page

4. Copyright Page

5. Table of contents

6. Preface

7. Scientific Committee

8. A safety analysis strategy for transmission lines considering power system oscillation

9. Neutral point potential balance strategy for NPC three-level inverter based on FOC-ADRC

10. Probabilistic power flow calculation of power system considering DGs based on improved LHS

11. A new sensorless vector control method for PMSM based on adaptive fuzzy sliding mode observer and Kalman filter

12. A novel soft-switching bidirectional DC-DC converter based on LLC resonance

13. The deadbeat current control of MMC rectifier with wide range output voltage

14. Control of active magnetic bearing system in accordance with state feedback theory

15. Impact of large-scale electric vehicle charging on a power grid and its optimal scheduling strategy

16. Research on active response control strategy of smart building micro-grid with energy storage system

17. Innovative floating support technologies for submarine cable landing

18. Fault detection and diagnosis of analog circuits based on LOGFA algorithm optimized ELM

19. Research on compensation strategy of UPQC based on super capacitor

20. Stability performance of an innovative submarine cable laying vessel during cable landing

21. Evaluation on performance of HESS-based grid-connected photovoltaic power system

22. Direct torque control of permanent magnet synchronous motor based on torque compensation and reference flux linkage calculation

23. A novel railway power conditioner based on modular multilevel converter with integrated super capacitor energy storage system

24. Investment and financing problems of the energy internet and suggestions

25. Research on a flexible AC/DC microgrid based on a power-coordinated control strategy

26. Fluid-structure interaction and performance analysis of an ocean current turbine

27. Research and analysis on the relationship between floating electrode discharge signal and ground current in electrical equipment

28. A coordinated damping control for ultralow-frequency oscillation in a DC isolated system

29. A method for testing the sensitivity of equipment to voltage sag

30. PIT analysis of typical industrial production processes under voltage sag

31. Calculation of formation pressure during drilling and shut-in of oilfields with multiwell and multilayer conditions

32. Multi-index program decision model for the development of a condensate gas reservoir group and its application

33. An analytical method for voltage sag profile estimation of a power system with STATCOMs

34. Evaluation of development effects of SZ36-1 oilfield after overall infilling

35. Cyberphysical paradigm of multiagent systems for smart microgrids

36. Analysis of the error of harmonic current detection based on the instantaneous reactive power theory

37. Method for evaluating the validity of synchronous generator model parameters considering disturbance scene classification

38. Method for judging the severity of atmospheric corrosion of power equipment metal based on colorimetric and topographical texture features

39. Safety analysis of entering equipotential on UHV transmission lines

40. Application of single-phase three-leg inverter for grid connected transformerless photovoltaic system

41. Sustainable development in green energies and the environment

42. Study on radiated electromagnetic disturbance characteristics of a ±800 kV VSC-HVDC converter valve

43. Research on multi-resource co-control method and defense system for bundled wind-thermal power transmission

44. An improved phase current reconstruction strategy for brushless DC motors with single current sensor

45. Operation optimization of an integrated energy system considering multiple redundant energy flow paths

46. Analysis of diesel engine pipeline vibration in a nuclear power plant

47. Integrated energy planning and technology application for an industrial park

48. Study on treatment of hydro turbine torque characteristic curve based on load shedding test

49. Analysis of energy price distortion based on time-varying elastic production function

50. Calculation and experiment of short-circuit fusing characteristics of copper and copper-clad aluminum earthing cables

51. Kinetic battery model application for capacity optimization of the wind/solar/battery stand-alone hybrid system

52. Optimal method for day-head dispatching of a multi-energy micro-grid

53. Research on integrated management system of power grid information of provincial and county based on the OMS system

54. Piecewise analytical expressions for electromagnetic field distribution within an apertured shielding enclosure

55. Analytical study of electromagnetic shielding characteristics of a wire mesh

56. Protection scheme for flexible DC distribution grids based on a full-bridge modular multilevel conductor

57. Measurement and analysis of the electromagnetic disturbance caused by the switching operation of distribution switchgear

58. An evaluating method of cloud matter–element theory and its application for developmental form of an urban distribution network

59. Wind farm layout optimization for minimum levelized cost of energy considering land lease cost, noise emission, and wake loss

60. Investigation of the hydraulic forces on the radial vibration of hydro-turbine units

61. A new protection principle of MMC-HVDC transimission lines with voltage polarity on both sides of the series inductor

62. Investigations of potential difference characteristics between two points on a grounding grid of a power substation

63. FEM analysis of iron core temperature distribution in a magnetically controlled shunt reactor with distributed magnetic valves

64. An effective health index calculation of 10 kV distribution transformer using fuzzy set theory and nonlinear fuzzy AHP

65. A two-settlement contract with risky power trading to reduce generation uncertainty and increase generation profit

66. Study on the characteristics of low voltage ride through for DFIG based on vector control and direct torque control technology

67. Research on electromagnetic disturbance and suppression measures at the secondary side of the voltage transformer in distribution switchgear

68. Classification and identification of temperature status of gas insulated switch gear isolation switch contacts based on a learning vector quantization neural network

69. Reliability analysis of distribution network considering wind and photovoltaic power

70. Prediction of dissolved gas concentration in power transformer oil based on the multivariate ReLu deep belief networks model

71. Feasibility study on reducing the grounding resistance of a transmission tower with conductive concrete

72. Thermoeconomic analysis and multiobjective optimization of a closed isobaric–compressed air energy storagesystem

73. Experimental study and simulation of CO2 membrane separation of coal-fired flue gas

74. Design of the electric power emergency repair system and its software architecture

75. Experimental investigation and mechanism analysis of NOx reduction by CH4 in the absence of oxygen

76. An identification method of weak links of overhead lines in distribution network based on typhoon scenario simulation

77. Research on the VIENNA rectifier based on backstepping control

78. Research on subsynchronous oscillation modal identification based on the FastICA–ARMA algorithm

79. Experimental and modeling investigations on impacts of deeply air staging in a 130 t/h tangentially firing furnace of pulverized coal

80. Wind power ramp forecasting based on deep metric learning

81. Research on the elements and model of the competitive electricity retail market

82. A tie-line power smoothing method for an office building Microgrid by scheduling thermal mass of the building and plug-in electric vehicles

83. A fault current calculation method in a neutral point ungrounded system for a single-phase ground fault

84. Compilation and calculation of prosperity index of power grid investment

85. Research on overseas investment value strategy of power grid project based on social network

86. Study on the influence of length on frequency response characteristics of grounding pole based on CDEGS

87. A method of single-phase ground fault line selection for distribution network based on correlation coefficient

88. Study of the modeling method of wind power time series based on correlation

89. Research on the post-evaluation of power transmission project based on GIOWA operator

90. Study on the effect of transition resistance on the frequency spectrum characteristics of rail impedance

91. Study on the influence of AC/DC power supply on the stray current of the subway tunnel

92. Research on transient voltage instability causes and counter-measures of multi-infeed HVDC receiving-end system

93. Estimation of shielding effectiveness of the lossy infinite plane with periodic circular apertures

94. An energy hub based planning method for a combined heat and power based microgrid

95. A scheduling method using a water pump and reservoir for renewable energy power accommodation

96. Graphical and unified analysis of the unsymmetrical shunt faults

97. Newton-Raphson discrete equivalent circuit models for the diode and their application to the photovoltaic modules

98. A multi-time scale optimization scheduling strategy of virtual power plant with responsive loads

99. Simulation and analysis of the near-field magnetic shielding effectiveness of shielding box with aperture at low frequency

100. Study on corrosion fault diagnosis for grounding grid based on the law of conservation of power

101. A planning approach of distributed generation and energy storage based on an improved parallel P-system algorithm

102. Research on three-phase unbalanced governance strategy of the microgrid based on improved PQ control

103. Study on shielding effectiveness characteristics of infinite metal sheet

104. Medium voltage DC switchboard failure mode and test method analysis

105. Research on differential transformation schemes of substation secondary equipment based on improved fuzzy analytic hierarchy processes

106. Application of high precision lightning location system in distribution network and influence of topography on lightning activity

107. Non-linear parameter optimization of power system stabilizers in interconnected multi-machine power systems

108. Study of energy generation through biogas from landfill waste

109. Comparing the wind and solar power uncertainty in virtual power plants using IGDT method

110. Evaluation bioethanol production from fusant of S. cerevisiae and P. stipitis

111. Methodology of analysis, modeling and supervision of SCADA systems in thermal power plants

112. Energy harvesting from the railroad bed: Choice of the optimum frequencies

113. Improved DFIG control with decoupled control to enhance LVRT response

114. Smart energy measurement using Ethernet

115. A novel low power BIST-TPG with reduced testing time

116. Straightforward derivation of the wye-delta transformations based solely on Kirchhoff’s law

117. Author Index